Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Gorilla Glue

  1. #11

    Default

    I've had really good results w/ roughing up both surfaces, then applying two-part 5-min epoxy to BOTH surfaces, making sure no air bubbles, and just putting together. I don't even bother clamping...just twist and slide the tip around a bit to make sure solid bond and let it dry. I've never had a tip pop off yet.

    aliasbigdog

  2. #12

    Default Re: Gorilla Glue

    Ive tried that Gorillia super glue & did not like it, I normally use Tigers cue tip glue which is a gap filling super glue, just make you don't get your finger stuck together. A little dab will do you, place a small amount in the ferrule & tip then spread it out with a razor blade then stick both parts together and apply pressure and wait 5min. minimum, I normally let it set & cure for 1hr then proceed on to the shaping.

    Thats all that i use.

    David Wayne

  3. #13
    Join Date
    Dec 2013
    Location
    Anaheim, CA
    Posts
    49

    Default Re: Gorilla Glue

    The glue is suitable for wood end grains since it is well absorbed in wood tubules. It is suitable for surfaces like stone, metal, glass and foam.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •